[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[TRNSYS-users] Adiabatic wall
Dear TRNSYS users,
I need to define an adiabatic wall in
TRNBuild. I think that it is possible by defining a "boundary" category for the
wall in which the "boundary temperature" is set up as "identical": in this case
in fact there aren't heat flows through the wall.
Is it the correct way to proceed? If yes, the
definition of an adiabatic wall is indipendend from the material of the wall or
need I to use a wall with low "global trasmittance" and "convective heat
transfer coefficient" too?
Best regards,
Eng. Maurizio Sorce
PhD Student of Department of Energy and
Environmental Research (DREAM)
Viale delle Scienze, Building 9,
I-90128
Italy (EU)
(+39) 091236012
(+39)
3495386296
_______________________________________________
TRNSYS-users mailing list
TRNSYS-users@xxxxxxxxxxxxx
https://www.cae.wisc.edu/mailman/listinfo/trnsys-users