RE: time of simulation error in upgrade

["Michaël Kummert"" <kummert@xxxxxxxxxxxxxxx>]

Ronny,

The "problem" you mention happens if you check "write TRNSED commands" in
the control cards.
TRNSED gives a menu to the user where you can select any start & stop time,
but the default value is always a one day simulation starting at 1.
If you do not run the simulation in TRNSED, turn the "write TRNSED commands"
option OFF.
As far as I know, this was already happening with the previous TRNSYS
releases.

Cheers,


Michael


_________________________________________________

Michael Kummert

Solar Energy Laboratory - University of Wisconsin-Madison
1303 Engr Res Bldg
1500 Engineering Drive
Madison, WI 53706

Phone: +1 (608) 263-1589
Fax: +1(608) 262-8464
E-mail: kummert@sel.me.wisc.edu <mailto:kummert@sel.me.wisc.edu>

SEL Web Site: http://sel.me.wisc.edu <http://sel.me.wisc.edu>
TRNSYS Web Site: http://sel.me.wisc.edu/trnsys
<http://sel.me.wisc.edu/trnsys>





-----Original Message-----
From: owner-trnsys@relay.doit.wisc.edu
[mailto:owner-trnsys@relay.doit.wisc.edu]On Behalf Of Ronny Glöckner
Sent: Friday, March 15, 2002 04:36
To: trnsys@relay.doit.wisc.edu
Subject: time of simulation error in upgrade


Hi there!

I have a lot of projects made in TRNSYS15.

These are running from 1 to 8760 hours (=years).

After updating to the latest version, I have uploaded this project again and
run it.

This will then only run for 24 hours (1 to 24) regardless of what is stated
in the proforma. WHY is this so?

Regards
Ronny

_______________________________________________________________
Ronny Glöckner - Research Scientist, PhD  tlf(w) +47 63 80 61 68
Institute for Energy Technology (IFE)	(p) 	 +47 22 65 16 33
Instituttveien 18					(mob)  +47 96 61 85 88
P.O. Box 40			 			fax(w) +47 63 81 29 05
N-2027 KJELLER			       	e-mail ronnyg@ife.no
http://www.ife.no