Re: [TRNSYS-users] Adiabatic boundary wall in TYPE56

[David Bradley <bradley@xxxxxxxxxxxx>]

Dear Xavier,
  With a BOUNDARY wall, you have the option of defining the
temperature on the other side of the wall as "userdefined"
(either an input, a constant value, or a schedule) or as
"identical." To define an adiabatic wall, simply set the
boundary temperature to "identical"
Kind regards,
  David

At 10:14 AM 12/2/2004, Xavier García Casals wrote:
> Hi,
> Is there a direct way to specify an adiabatic boundary wall in TYPE56?.
> From what I could find in the documentation, only boundary walls with a
> boundary temperature may be deffined. In principle setting a very small
> wall convection coefficient (HBACK) would fisically lead to an adiabatic
> condition, but from the manual it seems it leads to the oposite (wall
> temperature equal to boudary temperature). Two aproximations I can think
> of are to specify the identical condition, in which case an adiabatic
> plane would apear WITHIN the wall, or specifying a layer with a very high
> resistence at the outer side of the wall. But is there not a way to
> specify the boundary adiabatic condition straight?
> Regards,
> Xavier

****************************************************************************************
Thermal Energy System Specialists (TESS), LLC
David BRADLEY                           2916 Marketplace Drive - Suite 104
Partner                                        Madison, WI 53719
Phone: (608) 274-2577 USA
Fax: (608) 278-1475
E-mail: bradley@xxxxxxxxxxxx
Web Pages:  http://www.tess-inc.com     and      http://www.trnsys.com

"Providing software solutions for today's energy engineering projects"
****************************************************************************************