Hello everyone,
Has anyone experienced problems with obtaining simulation data
from a TYPE 56 Multi-Zone Building
I have set up the simulation to record the
sensible heat gains from a building which I have defined in PREBID. I have
connected a TYPE 28 Simulation Summary to the output of TYPE 56 but
unfortunately my output is reading zero heat gains. I am using my own
weather data file which consists of three columns of data as
follows:
Column 1. Radiation on a horizontal surface
(kJ/m2-hr)
Column 2. Dry-bulb temperature (C)
Column 3. Wet-bulb temperature (C)
I have connected two TYPE 16 Radiation
Processors (1 for the walls and 1 for a sloping roof) to the INPUT side of the
TYPE 56.
Can I take the liberty of asking you if you
could check my system to see where I am going wrong? I am quite new to
TRNSYS and although I have covered the examples in the manual it is quite
different once you try out your own simulations. I have archived and
attached the assembly panel (OfficeBlock.ia) as well as all the other relevant
files. My weather data file is LHRSummer.dat.
As well as the sensible energy gains I am using
an online plotter to display the relative humidity in four zones. Although
I am getting some readings I am not so sure that they are correct. Am I
correct in saying that TRNSYS will provide the Sensible Energy gains in units of
kJ/hr?
Mant thanks in advance for your help
Yan Kadis |
Attachment:
LHRSummer.dat
Description: Binary data
Attachment:
Officebl.ia
Description: Binary data
Attachment:
OfficeBlock.BLD
Description: Binary data
Attachment:
OfficeBlock.bui
Description: Binary data
Attachment:
OfficeBlock.INF
Description: Binary data