|
Hello!
Sorry to bother you,
but I need help again :-) Whenever I try to run a simulation for 7000 hrs or
longer, the simulation runs the entire period, then at the end of simulation the
following error message occurs:
Visual Fortran
run-time error
forrtl: error (63);
output conversion error, unit 6, file Project1.LST
My model simulates
over a short timestep (1 min). My guess is that there is too much information to
put in the list file, which causes this error. Could that be the case?If so;
Is there a way to run the simulation whitout creating a list
file?
Kind
regards,
Ulrika
Ottosson
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @
Ulrika Ottosson
e-mail:
ulrika.ottosson@tfe.umu.se
Tekniska högskolan, Umeå
universitet
(Umeå Institute of
Technology) tel:
+46 (0)90 786 67 20
S-90187 Umeå
Sweden
fax:
+46 (0)90 786 97 96
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
Hello I would like to know if ther is someone making a Trnsys modell for building structure heating system with integrated PCM (Phase Change Material)? Best Regards
Maha AHMAD
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
Testez le nouveau Yahoo! Mail
|