[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: output conversion error
- Date: Tue, 30 Sep 2003 13:37:58 +0200
- From: Arie Kalkman <a.kalkman@xxxxxxx>
- Subject: RE: output conversion error
Dear Ulrika,
You can select the "no list" button in your control cards.
I hope it helps.
Arie
-----Oorspronkelijk bericht-----
Van: Ulrika [SMTP:Ulrika.Ottosson@tfe.umu.se]
Verzonden: dinsdag 30 september 2003 13:29
Aan: trnsys@relay.doit.wisc.edu
Onderwerp: output conversion error
Hello!
Sorry to bother you, but I need help again :-) Whenever I try to run a
simulation for 7000 hrs or longer, the simulation runs the entire
period, then at the end of simulation the following error message
occurs:
Visual Fortran run-time error
forrtl: error (63); output conversion error, unit 6, file Project1.LST
My model simulates over a short timestep (1 min). My guess is that there
is too much information to put in the list file, which causes this
error. Could that be the case?If so; Is there a way to run the
simulation whitout creating a list file?
Kind regards,
Ulrika Ottosson
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @
Ulrika Ottosson e-mail:
ulrika.ottosson@tfe.umu.se
Tekniska hogskolan, Umea universitet
(Umea Institute of Technology) tel: +46 (0)90 786 67 20
S-90187 Umea
Sweden fax:
+46 (0)90 786 97 96
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @
-----Ursprungligt meddelande-----
Fran: owner-trnsys@relay.doit.wisc.edu
[mailto:owner-trnsys@relay.doit.wisc.edu] For maha ahmad
Skickat: Tuesday, September 30, 2003 9:54 AM
Till: trnsys@relay.doit.wisc.edu
Amne:
Hello
I would like to know if ther is someone making a Trnsys modell for
building structure heating system with integrated
PCM (Phase Change Material)?
Best Regards
Maha AHMAD
_____
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en francais !
Testez le nouveau Yahoo! Mail <http://fr.mail.yahoo.com>
<< Bestand: ATT00003.html >>