[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TRNSYS-users] parametric run


I am trying a parametric run. I am wondering if I'm doing things right. I create a trnsys file in IIsiBat. I open the so created .dck file in TRNSHELL. I replace some equations by a CONSTANT statement and create my parametric table.
But if I make any modification in IIsiBat, when I come back into TRNSHELL, I have to do these two operations again. Is that right ? (I hope mu explanation is not too confused...)

Unfortunately you are correct. There is no way back to IISiBat once you started editing a deck file in TRNSHELL (that is, there is a way back but you loose most changes).
Please note, however, that you can have CONSTANTS statements in IISiBat. You just have to enter them by hand in the "Simulation Cards" field in "Control Cards". You can use the constants in the project by typing their name in an initial value or parameter field (after setting the "type" to "string"). That way you can setup your simulation completely in IISiBat and just use TRNSHELL to run the parametric study.

Kind regards,

Michaël Kummert

-- _________________________________________________________

Michaël Kummert

Solar Energy Laboratory - University of Wisconsin-Madison
1303 Engr Res Bldg, 1500 Engineering Drive
Madison, WI 53706

Tel: +1 (608) 263-1589
Fax: +1 (608) 262-8464
E-mail: kummert@xxxxxxxxxxxxx

SEL Web Site: http://sel.me.wisc.edu
TRNSYS Web Site: http://sel.me.wisc.edu/trnsys
TRNSYS-users mailing list